|
17-9-proverka-urovnya-smazochnojj-zhidkosti-avtomaticheskojj-transmissii.html
17.9. Check of level of lubricant liquid of automatic transmission Two times year or each 10 000 km of run (that will come earlier)
|
|
Use of transmission liquid, excellent from specified in the Size table and adjusting data at the end of the Management, can lead to violations in work of transmission or to its refusal. |
Level of AT liquid should be supported accurately. The lack of liquid can lead to a soskakivaniye from transfer or to the termination of transfer of rotation on driving wheels while the modulation of liquid can lead to its loss as a result of foaming. Both that and another can serve as the reason of damage of transmission.
As transmission liquid extends when heating, it is necessary to measure its level when it warm, i.e. at normal working temperature. If the car just passed more than 32 km, it is possible to consider that transmission liquid rather warm. It is possible to measure level of transmission liquid also and in a cold condition. If the car staid more than five hours and liquid has the temperature close to room (i.e. 20 ° C), liquid it is possible to consider cold. However to measure level of warm liquid best of all and more precisely.
|
|
It is impossible to consider results of measurement of level of transmission liquid rather exact if the car just passed a big distance on high speeds, it was maintained in hot weather in the conditions of intense city movement or it was used for trailer towage. In this case wait for about 30 minutes before transmission cooling. |
|
|
- Right after a trip on the car park it on an equal platform, cock the parking brake and start the engine on single turns. Squeeze out a pedal of a brake and carry out the selector lever through all provisions, having begun and having finished on the situation "P" (parking).
- The jellied tube and щуп measurements of level of transmission liquid is in a back left corner of an impellent compartment.
|
|
- At the idling engine take щуп from a jellied tube, wipe it dry a piece of pure rags, again lower in a tube up to the end, pull out and define liquid level. Shchup of measurement of level of liquid of automatic transmission (it is specified by an arrow) is located at a partition in the left part of an impellent compartment.
|
- Level of liquid should be between two labels on щупе. If it is lower, than follows, add specified in the Size table and adjusting data at the end of the liquid Management through a jellied tube - use a pure funnel, it is desirable with the small mesh filter in order to avoid a spillage.
|
|
At a dolivka be careful, trying not to bring dirt in transmission. |
- Add in transmission only that amount of liquid which is necessary for achievement of the specified level. From bottom to the top label on щупе about 0.5 liters of hot liquid therefore add it gradually are required and each time check level before achievement demanded.
- The condition of liquid decides at the same time on level check. If liquid has black or dark red-brown color or a burned smell, it is necessary to replace it (see. Section Replacement of transmission liquid and AT filter). If you doubt concerning a liquid condition, buy new liquid and compare its color and a smell to the old.
|
|
|
|