12-5-osmotr-snyatie-i-ustanovka-tormoznogo-diska.html
12.5. Survey, removal and инсталляция of a жердь disk
|
This procedure belongs both тонна нападающего, and тонна выпекай тонну жерди disks. Жердь disks always should replaced or repaired в pairs (both лобби or both жарься disks), even в case one of them is damaged only. |
Survey
|
- Релиз bolts of fastening of wheels, поддомкратьте the автомобиль and reliably establish it on на одной оси поддержку. Remove a wheel and get three bolts тонна мило a disk on a place. ИФ you work with a выпекай жердь disk, релиз the parking жердь.
|
- Survey a disk surface on existence of scratches, мастера спорта and other damages. Slight scratches and superficial flutes ары admissible and usually чет. influence work of brakes, but deep scratches demand removal and disk replacement, or ИФ it is possible, the за пункт which has been камыш автомобиля вне моды by the эксперта в a repair грузовик. В the presence of мастеров спорта the disk should replaced. Чет. forget тонна экс-аминов both вечеринки of a disk.
|
- ИФ в operating назначило бы время of brakes strong vibrations were noticed, existence of деформацию of a disk (excessive palpation) is possible. ИФ the автомобиль is equipped with противоблокировочное устройство систему, чет. смешивай the вибрацию caused by деформацию of a disk, with нормально work of противоблокировочное устройство. At work of this систему usually there is a small вибрацию в a жердь педаль.
|
- Тонна measure disk palpation, establish the tsiferblatny indicator в a пункт located approximately в 13 мм from external edge of a disk. Establish the indicator в zero ситуации and rotate a disk. Indications of the indicator should exceed the limit established в the Size table and adjusting data at the of the менеджмент.
|
- ИФ всех of them exceed the established value (and ИФ palpation дремли occur owing тонна wear of the wheel bearing), it is necessary тонна replace a disk, or ИФ it is possible тонны pierce в a repair грузовик.
|
|
It is recommended тонна pierce disks irrespective of indicator indications тонна achieve a smooth, flat surface действовал, в занимайся гимнастикой, хочет help тонна avoid vibrations of a педаль of a жердь and other undesirable симптом connected with work of disks. В case всех of you decided тонна pierce disks, remove at берет напрокат luster from their surface by means of a скин or в emery paper, using roundabouts. |
|
|
- It is very важно тонна track, задний проход a за пункт the thickness of a disk did действовал become less limiting value specified в the Size table and adjusting data at the of the менеджмент. Минимум admissible thickness of a disk is beaten вне моды on a disk nave. It is possible тонны measure thickness of a disk by a micrometer.
|
|
|
Removal
|
|
- Give the screw of fastening of a disk...
|
|
... итак remove a disk from a nave.
|
|
- ИФ the disk "became attached" тонна a nave, inject plentiful amount of oil into зону between a nave and a disk and leave for some minutes тонну soften a rust between two components.
|
|
- ИФ the жарься disk nevertheless дремли отдельные, insert a thin flat screw-driver through в opening of a flange of a nave, занимайся гимнастикой в asterisk on the adjusting screw of the parking жердь and compress лодки of the parking жердь.
|
|
ИФ the нападающего disk "became attached", on some disks there is a possibility тонна insert two-three bolts в специально openings and тонна tighten them. Занимайся гимнастикой bolts в занимайся гимнастикой on pair of turns for once while the disk хочет released. |
|
|
Инсталляция
|
- Before инсталляция make суру действовала a disk absolutely чистые. ИФ for removal of a disk oil что used, make суру действовало on it did remain its traces. Establish a disk on a nave and get the фиксацию screw of a disk. Tighten it with demanded effort.
- Establish a язык программирования БЭЙСИК проверили бы of a поддержку (ИФ it что removed), жердь shoes and a поддержку (see. Sections Replacement of блока of disk жердь mechanisms and Removal, майора maintenance and инсталляцию of a поддержку of the disk жердь mechanism). Tighten вся фиксация детали with demanded effort.
- Establish a wheel, then lower the автомобиль on the earth. Squeeze вне моды a жердь педаль several times тонну приводи жердь shoes into contact with a disk.
- ИФ necessary adjust лодки of the parking жердь (The section Adjustment of the parking жердь).
- Carefully проверяй work of brakes before the beginning of нормально операцию of the автомобиль.
|
|
|
|