15-1-snyatie-proverka-raboty-i-ustanovka-otopitelya-i-kondicionera-vozdukha.html
15.1. Removal, проверяй of work and инсталляция of a heater and поведение conditioner Removal
|
The retro модели (Е28) use two отдельный мотор of superchargers: one for вентиляцию and heating. And another for поведение conditioning. Современно модели (Е34) have one мотор of the supercharger. Removal and инсталляция of the unique мотор of the supercharger, and the мотор for вентиляцию and heating of the retro модели ары described below. Removal and инсталляция of the мотор of the supercharger for поведение conditioning of the retro модели ары described в the Section Removal and accumulator инсталляцию / дегидратора центральное поведения of поведение of this Chapter. |
|
ИФ the радио receiver of your автомобиль is equipped with систему of protection against theft, make суру действовало you gathered the correct код before a battery detachment. |
|
- Disconnect a отрицательный wire of the battery.
|
- The мотор of the supercharger is located behind a раздел, under the access panel. Give screws of fastening of the panel в работает принудительно...
|
|
... and fastening from above мило this panel
|
- Disconnect or визитку off the plastic fastenings холдинг-компанию conducting on the panel, and take conducting aside.
- Remove the panel.
|
- Не значок a фиксацию клипс of a casing of the supercharger, and a клипс холдинг-компанию the мотор of the supercharger.
|
|
- Disconnect conducting and remove the мотор of the supercharger.
|
|
|
Проверка
You can проверяй the мотор of the supercharger, having submitted напряжение from the battery on мотор plugs, having used the incorporated wires from a комплект for автомобиль старт from в external source (make сура действовала толстый of the поклонника воздух anything at вращение) хочет. ИФ the мотор of the supercharger rotates поклонника толстый with a high скорость (this тест is calculated on its скорость high work), it means действовало it is serviceable. ИФ the мотор дремли work, or works slowly or is noisy, replace it.
|
ИФ it is necessary тонна remove assemblies of толстый of the поклонника, Марка their размещение on a shaft. At планирует тезис assemblies were balanced and ИФ тонна establish them в точно the семя ситуацию в соотношении тонна a shaft, it can lead тонна excessive noise at their work or тонна premature wear of bearings. |
Инсталляция
Инсталляция make upside-down.
|
For the correct инсталляцию of a фиксацию клипс, probably, it is required тонна выполняй the мотор of the supercharger. |
|
|