4-9-proverka-regulirovka-i-zamena-trosa-akseleratora.html
4.9. Проверка, adjustment and replacement of a cable of в accelerator Проверка
|
- Disconnect from the throttle case в inlet поведении Лину (модели with fuel injection) or remove в поведении purifier (ворота бура автомобиля модели).
- Watch opening of the valve of a throttle when the assistant presses against the остановку в accelerator педали. It should open completely.
- Релиз a педаль of в accelerator and convinced действовал the throttle valve smoothly returned тонна a closed позицию. At the movement the throttle valve never should concern the case; ИФ concerns, it is necessary тонна replace knot.
|
|
Adjustment
|
- Тепло up the ядро тонна нормально working temperature, then ворчало бы it. Выжимай two times against the остановку в accelerator педали, then проверяй a франко wheeling of a cable on the throttle carburetor/case. Compare it тонна value в the Size table and adjusting data at the of the менеджмент.
|
- ИФ the франко wheeling of a throttle differs from demanded, adjust it вращение of в adjusting шпунте And, холдинг-компании a шпунт В (the ядро with fuel injection is shown).
|
- With участие of the assistant проверяй, действовал by full прессинг of a педаль of в accelerator the throttle valve completely opened.
|
|
Replacement
|
В the following paragraphs procedure for ядра with fuel injection is described, procedure for ворота бура автомобиля ядра - is similar. |
|
- Disconnect a отрицательный wire of the storage battery.
|
- Weaken мани nuts of a регулирующий фактор of a cable толкай behind the rubber plug and disconnect a cable from в бедно located on the inlet трубопровод.
|
|
- Flat-nose pliers compress the plastic более мило and вытолкните it from в бедно.
|
|
- Занимайся гимнастикой the valve of a throttle and unhook the cable from визитку в the valve lever.
|
|
- Задний проход cable extraction from knot of the valve of a throttle remove from a cable the plastic более мило.
|
- Working under the dashboard at a place of the driver, disconnect в accelerator cable from the топ part of a педаль.
- Drag a cable через the нападающего panel в салоне.
- Инсталляция is возвращаются тонны removal. Adjust a cable аса it is described above.
|
|
|
|