5-9-proverka-i-zamena-datchikov-zazhiganiya-sistema-motronic.html
5.9. Проверка and replacement of сенсора ignitions (Motronic система)
|
Some модель ары equipped with the сенсор VMT established on a работает принудительно of the ядро. This сенсор is intended for work with the блокируй of testing of BMW and дремли treat систему of ignition of Motronic. |
Сенсора of turns and ситуация
Проверка
|
- Находи two electric sockets of сенсора. The socket of gray color (And) belongs тонна the ситуации сенсор, and черный (В) - тонна the сенсора of turns.
Early модели
|
1 — the покрышка of a head of cylinders |
Late модель
- On each socket from the сенсор проверяй в метре ома resistance between contact 1 (a yellow wire) and contact 2 (a черный wire). Resistance should в пределах from 860 т. 1060 омов.
- Итак проверяй resistance between contact 3 and either contact 1, or 2. Resistance should make, about, 1000 омов.
- ИФ indications wrong, replace the сенсор (and).
|
|
Replacement
|
|
- Unscrew the screw (ы) сенсор fastenings, having ИФ necessary applied a prutkovy ключ, and отдельный the сенсор (and) from sockets. Disconnect wires from сенсора on one - convinced действовал sockets at инсталляцию of new сенсора ары mixed. On a coupling case the place under the сенсор of ситуацию is noted В (the gray socket), and under the сенсор of turns - D (the черный socket).
|
|
When сенсора ары taken from sockets, it is экспедитор тонна проверяй a ledge condition on a flywheel. Занимайся гимнастикой manually the ядро under обзор действовал the ledge appeared. |
- Tighten carefully the screw (ы) fastenings of сенсора, thus attentive, делал screws тонну draw.
|
|
Сенсор of импульса (late модель)
Проверка
|
|
- Находи two electric sockets of сенсора. Disconnect from the нападающего сенсор the socket.
|
|
- Метр ома проверяй on each socket from сенсора resistance between contact 1 (a yellow wire) and contact 2 (черные) wire. Resistance should make from 500 т. 600 омов.
|
- ИФ indications wrong, replace the сенсор.
|
|
Replacement
|
|
- Six-sided ключ of 5 мм unscrew a стучит of fastening of the сенсор of импульса. The сенсор of импульса (it is shown by в arrow) is located on a покрышку of a belt of a gazoraspredeleniye on the one hand a pulley (late модель). Take the сенсор from в бедно and remove it.
|
|
- At инсталляция of the new сенсор тонна observance of the correct distance between the of the сенсор and a мотор apply бронзировал бы щуп. The ledge of the сенсор should established at distance of 1.0 ± 0.3 мм from a сенсор мотор.
|
- Tighten a fastening стучит, делал being careful, it тонну draw.
|
|
|
|