9-1-5-snyatie-i-ustanovka-transmissii.html
9.1.5. Removal and трансмиссия инсталляцию
Removal
|
- Disconnect a отрицательный wire of the battery.
- Remove релиз систему (look Head the сила supply систему).
- Remove the в виде драйва (look Head the трансмиссия Лину).
- Disconnect draft of the mechanism of gear shifting (look the Section Removal and инсталляцию of the lever of the switch).
- Unscrew bolts and remove рука of fastening of the case of the mechanism of gear shifting. Before it convinced действовал draft of the mechanism is completely disconnected.
- Disconnect and remove from трансмиссию the сенсор VMT, the сенсор of turns/ситуацию and the switch of a реверсы gear ИФ ары applied (look Head ignition систему).
- Remove the working cylinder of coupling (look Head Coupling). Чет. disconnect a hydraulic брюки of coupling. Постоянно the working cylinder a wire.
|
Чет. выжимай a coupling педаль when the working cylinder is removed from трансмиссию. ИФ the pusher is squeezed вне моды from the cylinder, the working cylinder can damaged. |
- Поддержка трансмиссию by a Джека for трансмиссию or a самокат Джека and remove nuts of fastening of поддержку.
- Carefully lower the трансмиссию / ядро assembled while they хочет lay on a кросс piece.
|
Never allow трансмиссию тонна склонности without поддержку on в entrance shaft of трансмиссию. Ищи loading хочет damage coupling and coupling components. |
- Remove bolts of fastening of трансмиссию тонна the ядра. Some bolts can have a head under a prutkovy ключ, the специально prutkovy head is necessary for тезис bolts.
- Carefully отдельный from the ядро трансмиссию. convinced действовал on в entrance shaft of трансмиссию it is created any loading. Lower a Джека действовал there что enough place for трансмиссию extraction from under the автомобиль.
|
|
Инсталляция
|
- Инсталляция, is генное ралли возвращаются тонны removal. Чет. forget тонна grease slightly with Microlube GL 261 greasing or it a similar shlitsa of в entrance shaft, then carefully establish трансмиссию on the ядро.
|
Shlitsa of в entrance shaft and a shlitsa of a disk of coupling can coincide; в this case for в insignificant provorachivaniye of a cranked shaft занимайся гимнастикой a ключ a pulley of a cranked shaft. |
|
BMW recommends тонна grease shlitsa of a disk of coupling and в entrance shaft of трансмиссию only with Microlube GL 261 greasing. Otherwise the disk of coupling can become attached тонна в entrance shaft and gear shifting хочет complicated. Microlube GL 261 can got at дилера of BMW (BMW a part of No 81229407436). |
|
ИФ one of bolts of трансмиссию has a head under a prutkovy ключ, чет. forget тонна establish a washer; инсталляция of bolts without washers can lead тонна таким образом dense contact of heads of блока тонна a трансмиссию case действовала they хочет need тонна turned on. |
- ИФ from трансмиссию oil что merged, задний проход инсталляцию чет. forget тонна fill в в it the correct oil.
|
|
|
|