General information. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
12.1. General information
12.2. General information on anti-blocking brake system
12.3. Replacement of blocks of disk brake mechanisms
12.4. Removal, major maintenance and installation of a support of the disk brake mechanism
12.5. Survey, removal and installation of a brake disk
12.6. Replacement of boots of drums of brake mechanisms
12.7. Removal and installation of the main brake cylinder
12.8. Condition check, removal and installation of the vacuum amplifier of brakes
12.9. Description, removal and installation of the vacuum hydraulic booster of brake system
12.10. Replacement of a cable (cables) of a drive of the parking brake
12.11. Adjustment of the parking brake
12.12. Condition check, removal and installation of assembly of the parking brake
12.13. Adjustment of a pedal of a brake
12.14. Check and adjustment of the switch of a stoplight
12.15. Survey and replacement of brake lines and hoses of hydraulic system of brakes
12.16. Pumping of hydraulic system of brakes
12.17. Diagnostics of malfunctions of brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 






cream chargers







12-1-obshhaya-informaciya.html

12.1. General information

General information

All E28 models (with "retro" - a body) are equipped with disk forward brakes, and either drum-type, or disk back brakes. (With a modern body) lobbies and back disk brakes have the E34 models. Both forward, and back brakes on all models the self-regulating. Some latest models are equipped with anti-blocking brake system (ABS); it is described in the Section the General information on anti-blocking brake system.

Hydraulic system

The hydraulic system consists of two separate contours. The main cylinder has separate tanks for each of two contours, and in case of leakage of liquid or refusal of one of contours another will continue to work.

Vacuum amplifier

The vacuum amplifier using vacuum and atmospheric pressure of the inlet pipeline of the engine for ensuring of strengthening of hydraulic system of brakes, is established on a partition of an impellent compartment.

On the E28 models the hydraulic amplifier is established. This system uses hydraulic pressure of the steering pump for strengthening of brake system.

Parking brake

The parking brake is connected with back brakes and is put in action by a cable by means of the lever located on the central console. Assembly of the parking brake on models with back drum-type brakes is a self-regulating part of assembly of the back drum-type brake mechanism. With back disk brakes the parking brake works at models by means of pair of the brake boots located in the central part of a back brake disk, and is regulated manually.

Alarm system of wear of brake shoes

The alarm system of wear of brake shoes is connected with a red alarm lamp on an instrument guard which is lit when brake shoes wear out to a condition demanding their replacement. DO NOT IGNORE this signal. If you do not replace a block shortly after this lamp lit up, brake disks will be damaged.

On some models the alarm system of wear of brake shoes also includes a lamp of a warning signal which lights up only when the brake pedal is squeezed out to warn you in advance that it is necessary to replace blocks.

The sensor of wear fastens to brake shoes. It is located on the left forward wheel; on some models there is a sensor and on the right back wheel. The sensor of wear is a part of the closed chain. As soon as blocks wear out to level of contact with the sensor, the disk starts to erase that part of the sensor that is turned to a disk. The wire in the sensor thus frays and the red lamp on an instrument guard is lit.

Always check the sensor (and) at replacement of blocks. If you replace blocks before the alarm lamp, the sensor lights up (and) can remain serviceable; if the signal already lit up, it is necessary to replace the sensor.

Service

After completion of any procedure demanding dismantling of any part of brake system, always do trial departure to check work of brakes before normal operation of the car. Check of brakes make on a pure, dry and equal surface. Otherwise results of testing will be inexact.

Check brakes on different speeds, by easy and strong pressing a brake pedal. The car should stop evenly, without turning in one party. Avoid blocking of brakes since it leads to sliding of wheels, reduces efficiency of braking and reduces controllability of the car.

The condition of tires, loading of the car and corners of installation of forward wheels also influence operation of brake mechanisms.


«on page back
12. Brake system
on page forward»
12.2. General information on anti-blocking brake system