|
12-10-zamena-trosa-trosov-privoda-stoyanochnogo-tormoza.html
12.10. Replacement of a cable (cables) of a drive of the parking brake
|
|
|
|
- Unbend a cover at the basis of the lever of the parking brake and give a nut of adjustment of a cable of the parking brake which also holds a cable on the brake lever (both are specified by shooters). There are two cables - on one on each back wheel - and nuts for each cable. On some models to get access to these nuts, it is necessary to remove completely central console.
|
- To Poddomkratta the car and reliably establish it on axial support.
- Remove a drum (see. The section Replacement of boots of drums of brake mechanisms) or a disk (see. Section Survey, removal and installation of a brake disk) back brake mechanism.
|
|
... then pull out a finger holding a cable on an internal cam and remove an internal cam
|
- On models with back drum-type brake mechanisms pull out a cable and its cover from the back party of a board of a brake, then release a cable cover from clips on the back party of the longitudinal lever (easier to pull out an old cable and to insert new at the straightened cover, than at braided). On models with back disk brake mechanisms there is no need to disconnect a cable cover from a brake board, but for convenience it is better to release it from clips and directing to reduce its bends.
|
|
- Pull out a cable from a cover from a wheel.
|
- Grease a new cable with universal greasing, then insert it into a cover and push through so that its end left at the lever of the parking brake.
- Push a cable cover through a board of a brake and attach the back end of a cable to the lever of the parking brake (for models with back drum-type brake mechanisms) or to the executive mechanism (for models with back disk brake mechanisms). Make sure that you did not overwind a cable during its connection.
- Establish a cable cover back in clips from a reverse side of the longitudinal lever.
- On models with back drum-type brake mechanisms establish brake boots and a drum (see. Section Replacement of boots of drums of brake mechanisms). On models with back disk brake mechanisms establish boots of the parking brake and the executive mechanism (see. The section condition Check, removal and installation of assembly of the parking brake), and also a back brake disk (see. Section Survey, removal and installation of a brake disk).
- Lower the car on the earth and establish an adjusting nut on the lever of the parking brake. Adjust a cable of the parking brake (see. The section Adjustment of the parking brake) also establish a cover of the lever of a brake.
|
|
|
|