Removal and installation of a bar of the back stabilizer. BMW the 5th E28/E34 series (from 1981 to 1993 of release) 18+
Последние Криминальные Новости сегодня Москва. автомобилей техническое обслуживание
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
11.1. Steering
11.2. Forward suspension bracket
11.3. Suspension bracket of back wheels
11.3.1. General information
11.3.2. Removal and installation of assembly of the back shock-absorber and twisted spring
11.3.3. Removal and installation of a bar of the back stabilizer
11.3.4. Removal and installation of back longitudinal levers
11.3.5. Replacement of bearings of back wheels
11.3.6. Diagnostics of malfunctions of a suspension bracket of back wheels
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 








11-3-3-snyatie-i-ustanovka-shtangi-zadnego-stabilizatora.html

11.3.3. Removal and installation of a bar of the back stabilizer

Removal

The back bar of the stabilizer fastens generally equally on all models. Follow these general instructions on removal and installation, remembering possible deviations.


 PERFORMANCE ORDER

  1. Block forward wheels, then поддомкратьте a back of the car and reliably establish it on axial support.
  2. Give bolts or nuts of an arm of a bar of the stabilizer.
  1. Disconnect a bar from its links on both ends remove a bar. The bolt connecting a link of a back bar of the stabilizer to the longitudinal lever is specified by an arrow.
  1. Examine, and if necessary replace all damaged bolts, washers, plugs or links.

Installation

Installation make upside-down. Reliably tighten all fixture.


«on page back
11.3.2. Removal and installation of assembly of the back shock-absorber and twisted spring
on page forward»
11.3.4. Removal and installation of back longitudinal levers