Removal and installation of glass of a door. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
13. Body
13.1. Removal and front grille installation
13.2. Removal, installation and cowl adjustment
13.3. Removal and installation of bumpers
13.4. Removal and installation of the panel of an internal covering of doors
13.5. Removal, installation and door adjustment
13.6. Removal, installation and adjustment of a trunk lid / door of a back
13.7. Removal, installation and adjustment of a latch, cylinder of the lock and door handles
13.8. Removal and installation of glass of a door
13.9. Removal and installation of a window regulator of a door
13.10. Removal and installation of an external mirror
13.11. Removal and installation of casings of a steering column
13.12. Removal and installation of seats
13.13. Check of seat belts
13.14. Care of the car and coloring
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













13-8-snyatie-i-ustanovka-stekla-dveri.html

13.8. Removal and installation of glass of a door

If the radio receiver on your car is equipped with system of protection against theft, make sure that you gathered the correct code before disconnecting a battery wire. Apply for information in the Section System of protection of an audiosystem from theft and language of an instrument guard before a wire detachment.


If after wire accession on your instrument guard there were inscriptions not in that language which is necessary to you, address to the Section System of protection of an audiosystem from theft and language of an instrument guard where procedure of installation of the necessary language is described.


 PERFORMANCE ORDER

  1. Disconnect a negative wire of the battery.
  2. Remove the panel of a covering of a door and a plastic sealant (see. Section Removal and installation of the panel of an internal covering of doors).
  3. Remove internal and external sealing strips from a door.

Forward door

 PERFORMANCE ORDER

  1. Lift door glass so to provide access to fixing bolts through an access opening. On models with electric window regulators for this purpose temporarily disconnect a battery wire.
  2. Prop up glass and give bolts of fastening of glass to a window regulator.
  3. Lift glass up that it left a window aperture, then incline it and pull out from a door.
  4. Installation make upside-down.

Back door

 PERFORMANCE ORDER

  1. Make all operations described in item 1-3 and 1-2.
  2. Release a bolt of fastening directing back glass.
  3. Unfasten glass from a lobby roller directing, disconnect it from rails directing, then take away glass back and remove, having grasped it from above.
  4. Motionless glass can be removed, having given bolts of rails directing and then having pulled rails down and back and disconnecting glass.
  5. Installation make upside-down. Back glass can be adjusted, having released adjusting bolts and then having lifted glass to height about 3 cm from top of a window aperture. Adjust distance between glass and an aperture that it was identical on all length, and then reliably tighten bolts.


«on page back
13.7. Removal, installation and adjustment of a latch, cylinder of the lock and door handles
on page forward»
13.9. Removal and installation of a window regulator of a door