17-19-proverka-i-regulirovka-zazorov-klapanov.html
17.19. Проверка and adjustment of gaps of valves Annually or each 20 000 км of биржевую панику
|
This procedure дремли belong тонна the M10 ядро which has automatic регулирующего фактора. |
Gaps of valves can checked both at warmed up, and at the cold ядро, but кип в мин. действовал the received sizes should differ depending on ядро temperature. ИФ you ары going тонна carry вне моды procedure of проверяй and adjustment of gaps at the warmed-up ядро, it is necessary тонна старта it, тонна тепло up тонна нормально working temperature and then тоннам switch off.
|
ИФ gaps of valves ары regulated at the warmed-up ядро, it is necessary тонна especially careful тонна avoid burns. |
|
- Не покрышка heads of cylinders the ядро (see. A part the Repair work which is камыш автомобиля вне моды without extraction of the ядро from the автомобиль).
- Выполняй the ядро таким образом the нападающий делал звук пи No. 1 что в the топ dead пункт (VMT) of a step of compression (see. A part the Repair work which is камыш автомобиля вне моды without extraction of the ядро from the автомобиль).
- Проверка gaps of valves for the cylinder No. 1. Demanded sizes of gaps ары specified в the Size table and adjusting data at the of the менеджмент.
- The gap is measured by в объявлении way щупа a measuring инструмент of the demanded size between the of a rod of the valve and the adjusting клоуна of the lever of the valve. Shchup should подходи в a gap with some resistance.
|
- ИФ the gap is too great or too small, weaken a lock-nut, insert a hook from a thick metal wire and выполняй the клоуна before achievement of the necessary gap.
|
- Задний проход gap инсталляцию reliably tighten a lock-nut, холдинг-компанию the клоуна в reached ситуации with the help of a hook. Once again проверяй gap size - sometimes it slightly обмена денег задний проход a lock-nut tightening. В this case adjust it тонна the necessary size.
- On M10 ядра valves ары regulated в в operating procedure of cylinders, namely 1-3-4-2. Задний проход adjustment of valves of the вершину cylinder занимайся гимнастикой the crankshaft on a помогал of занимайся гимнастикой (180 °), then проверяй and adjust valves on the third cylinder. Repeat procedure on other cylinders.
- On ядра M20 and М30 valves ары regulated в в operating procedure of cylinders, namely 1-5-3-6-2-4. Задний проход adjustment of valves of the вершину cylinder занимайся гимнастикой the crankshaft on a занимайся гимнастикой third (120 °), then проверяй and adjust valves on the fifth cylinder. Repeat procedure on other cylinders.
- Establish a покрышку of a head of cylinders (use new laying) and tighten фиксацию nuts exactly and reliably.
- Старт проверяй the ядро and, whether there ары no leakages of oil between a покрышку of a head of cylinders and a head of cylinders.
|
|
|
|