13-2-snyatie-ustanovka-i-regulirovka-kapota.html
13.2. Removal, installation and cowl adjustment
|
The cover of a cowl is quite heavy and it is inconvenient to remove and establish it - performance of this procedure needs not less than two people. |
Removal and installation
|
|
- Open a cowl. On some latest models, probably, it is required to unbend plastic clips and to remove insulating laying, to provide access to the socket of illumination of a cowl and hoses of a washer of a windscreen. By means of a small screw-driver hook a plastic clip.
|
- After that disconnect wires and hoses.
|
- Remove clips and pull out fingers of an emphasis of a cowl nippers.
|
|
- Prop up a cowl and pull out sharnirny fingers of loops.
|
- Ask the assistant to support a cowl cover on the one hand, and support it with another.
|
- Give a coupling bolt of fastening of loops to a cowl of you, then hold your party of a cowl while the assistant gives such bolt on the other hand.
|
- Remove a cowl. Place it in a safe place where it will not drop, previously having wrapped up rags not to damage paint.
- Installation make upside-down.
|
|
Adjustment
Adjustment of a cowl can be made after holiday of bolts of loops of a cowl in order that it was flush with wings. On some models for access to bolts of loops it can be demanded to remove lateral parts of a front grille.
|
- Move a cowl here and there or forward and back properly to level the provision of a cowl concerning wings in front. Reliably tighten bolts.
|
- Height of a back part of a cowl it is possible to adjust, having released bolts and having lifted or having lowered a latch. After adjustment reliably tighten bolts.
|
|
- Lateral adjustment of a cowl can be made if to weaken nuts of a bolt roller directing and to move directing that it was reliably hooked with a latch.
|
|
- After adjustment screw in or unscrew cowl stoppers to hold him in new situation.
|
- Not to allow jamming of the mechanism of a cowl, it is necessary to grease it periodically.
|
|
|
|