General information. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
11.1. Steering
11.2. Forward suspension bracket
11.2.1. General information
11.2.2. Removal and installation of the forward stabilizer
11.2.3. Survey, removal, installation and replacement of plugs of the lever of a suspension bracket and basic levers
11.2.4. Removal and installation of assembly of a rack of a forward suspension bracket
11.2.5. Rack or shock-absorber replacement / twisted spring
11.2.6. Check and replacement of spherical support
11.2.7. Removal and installation of assembly of a forward nave and bearing
11.2.8. Diagnostics of malfunctions of a forward suspension bracket
11.3. Suspension bracket of back wheels
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













11-2-1-obshhaya-informaciya.html

11.2.1. General information

General information

Components of a forward suspension bracket and steering system (it is shown for models with left foreign management)

1 — the Stretcher
2 — a stabilizer Bar
3 — the Link of a bar of the stabilizer
4 — the Central steering draft
5 — External steering draft

6 — the Tip of steering draft
7 — the Rotary lever
8 — the suspension bracket Lever
9 — the Basic lever
10 — the Rack


Each time during the easing or removal of any fixing details of a suspension bracket or system of a steering should be checked them and if necessary to replace, and these details should be or the same number, as replaced, or not different from them on quality and design. All fixing details are necessary for tightening with demanded effort, for the correct assembly and safety of components. All pognuty or damaged details should be replaced.

Forward suspension bracket - rack-mount, type MacPherson. Racks are attached by the top ends to the strengthened platforms in the top part of wheel arches, and the bottom ends - to rotary levers/levers of a suspension bracket. The bar of the stabilizer fastens to the lower part of a body.


«on page back
11.2. Forward suspension bracket
on page forward»
11.2.2. Removal and installation of the forward stabilizer