Removal and installation of the forward stabilizer. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
11.1. Steering
11.2. Forward suspension bracket
11.2.1. General information
11.2.2. Removal and installation of the forward stabilizer
11.2.3. Survey, removal, installation and replacement of plugs of the lever of a suspension bracket and basic levers
11.2.4. Removal and installation of assembly of a rack of a forward suspension bracket
11.2.5. Rack or shock-absorber replacement / twisted spring
11.2.6. Check and replacement of spherical support
11.2.7. Removal and installation of assembly of a forward nave and bearing
11.2.8. Diagnostics of malfunctions of a forward suspension bracket
11.3. Suspension bracket of back wheels
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













11-2-2-snyatie-i-ustanovka-perednego-stabilizatora.html

11.2.2. Removal and installation of the forward stabilizer

Removal

 PERFORMANCE ORDER

  1. To Poddomkratta a car front also establish it on axial support.
  1. If you replace rack assembly, give a nut (it is specified by an arrow) fastenings of a bar of the stabilizer to a connecting link (is shown the left side, right same), disconnect a bar link from the rack case.
  1. Give bolts from arms of a bar of the stabilizer which fix a bar to a stretcher.
  1. Remove a stabilizer bar from the car. Where it is necessary, give bolts (are specified by shooters) on arms of a bar of the stabilizer and disconnect a bar from a rack arm.

Installation

Installation make upside-down. Do not forget to tighten all nuts and bolts with demanded effort.


«on page back
11.2.1. General information
on page forward»
11.2.3. Survey, removal, installation and replacement of plugs of the lever of a suspension bracket and basic levers