Removal and installation of the lever of the switch. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
9.1. Manual box of gear shifting (RKPP)
9.1.1. General information
9.1.2. Removal and installation of the lever of the switch
9.1.3. Replacement of epiploons
9.1.4. Check and replacement of support of transmission
9.1.5. Removal and transmission installation
9.1.6. General information about major maintenance of transmission
9.1.7. Diagnostics of malfunctions of manual transmission
9.2. Automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













9-1-2-snyatie-i-ustanovka-rychaga-pereklyuchatelya.html

9.1.2. Removal and installation of the lever of the switch

Removal

 PERFORMANCE ORDER

  1. Establish transmission in the provision of a reverse gear. Lift a front of the car and establish it on supports. For prevention of an otkatyvaniye do not forget to establish under back wheels an emphasis.
  2. Pull the button of the lever of the switch up and take it from the lever.
  3. Remove a frame of the lever and a sound-proof material under it.
  4. Remove a rubber dustproof cover. On models with the aluminum case of the mechanism of switching before removal of a cover disconnect the socket of the switch of a reverse gear.
  1. Working under the car disconnect from a switch (3) rod the switch (2) lever, having removed a fixing clip (1).
  1. On models with the stamped steel case of the mechanism of switching remove in the top part the bearing of the lever of the switch a lock ring and take the lever.
  1. On models with the aluminum case of the mechanism of switching from under the bottom bearing of the lever of switching insert into grooves of a lock ring of the bearing two screw-drivers. For a rasstoporeniye of a ring turn it on a turn quarter counter-clockwise and take the switch lever.

Installation

Installation is return to removal procedure.


«on page back
9.1.1. General information
on page forward»
9.1.3. Replacement of epiploons