Removal and installation of power shafts. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
10.1. General information
10.2. Removal and driveshaft installation
10.3. Check of work and replacement of the elastic coupling
10.4. Check and replacement of the central bearing
10.5. Check and replacement of kardanny hinges
10.6. Check and replacement of a lobby of the centering directing
10.7. Replacement of the hinge of equal angular speeds of the driveshaft
10.8. Removal and installation of power shafts
10.9. Check and replacement of CV JOINTS and their protective covers
10.10. Replacement of lateral epiploons of a case of differential
10.11. Removal and installation of a casing of differential
10.12. Replacement of an epiploon of a gear wheel
11. Steering and suspension bracket
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













10-8-snyatie-i-ustanovka-privodnykh-valov.html

10.8. Removal and installation of power shafts

Removal

 PERFORMANCE ORDER

  1. Cock the parking brake. Weaken bolts of fastening of a back wheel, but yet do not give them. To Poddomkratta a back of the car and reliably establish it on axial support. Remove a wheel (wheels).
  1. Wipe internal and external CV JOINTS to prevent dirt hit inside at their opening. Give six six-sided bolts on the internal CV JOINT and disconnect it from an internal flange.
  1. Give six six-sided bolts on the external CV JOINT and disconnect it from an external flange.
  1. Remove a power shaft.

Installation

Installation make upside-down. Do not forget to tighten six-sided bolts of the CV JOINT with demanded effort.


«on page back
10.7. Replacement of the hinge of equal angular speeds of the driveshaft
on page forward»
10.9. Check and replacement of CV JOINTS and their protective covers