|
10-11-snyatie-i-ustanovka-kozhukha-differenciala.html
10.11. Removal and installation of a casing of differential Removal
|
|
- To Poddomkratta a back of the car and reliably establish it on axial support. Merge lubricant liquid of differential (see. Head Routine maintenance of the car).
- Disconnect the driveshaft from a gear wheel flange (see. Section Removal and driveshaft installation). Suspend the driveshaft end on a piece of a wire not to damage the central bearing.
- To Otboltita the internal ends of power shafts from differential flanges (see. Section Removal and installation of power shafts). Suspend power shafts on pieces of a wire not to damage CV JOINTS.
|
|
- Disconnect wires from the speedometer sensor, give two fixing bolts of the sensor (one of them is specified by an arrow) and remove the sensor.
|
- Prop up differential a telezhechny jack.
|
|
- Give two back fixing bolts (are specified by shooters) in the top part bearing the back bridge (the left side is shown)
|
|
|
- Give a forward fixing bolt of differential (it is specified by an arrow).
|
- Lower differential and take it from under the car.
|
|
Installation
|
|
- Place a differential casing into place on its support and get bolts (do not tighten them while all will not be got), then reliably tighten fixture.
- The rest of procedure of installation make as it should be, the return to removal.
|
|
|
|