Removal and evaporator installation. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
15.1. Removal, check of work and installation of a heater and air conditioner
15.2. Removal and control unit installation by operating modes of a heater and air conditioner
15.3. Removal and installation of the heat exchanger of a heater
15.4. Conditioner and precautionary measure service
15.5. Removal and installation of the compressor of central air of air
15.6. Removal and installation of the motor of the supercharger of the conditioner (E28 model / "retro")
15.7. Removal and installation of the condenser of central air of air
15.8. Removal and installation of an accumulator / degidrator of central air of air
15.9. Removal and evaporator installation
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 








15-9-snyatie-i-ustanovka-isparitelya.html

15.9. Removal and evaporator installation

As work with system is potentially dangerous, we urgently recommend to provide all works connected with central air of air, to dealer office of the BMW service or the expert in conditioners. At least, do not remove any components of system (hoses, the compressor, shtutserny connections, etc.) to a full discharge of system the qualified expert. Read about precautionary measures at the beginning of the Section conditioner and precautionary measure Service.

Removal

 PERFORMANCE ORDER

  1. Make a discharge of central air of air (see. The prevention is higher).
  2. Remove the covering panel on the parties of the central console (see. Head Body).
  3. Disconnect an electric wire and remove the evaporator sensor.
  4. Uncover the evaporator and open refrigerator lines.
  5. Disconnect refrigerator lines from the evaporator.
  6. Take the evaporator from a casing.

Installation

 PERFORMANCE ORDER

  1. Installation make upside-down.
  2. Make an oporozhneniye, a charging and system check on existence of leaks by means of the same qualified expert who made its discharge.


«on page back
15.8. Removal and installation of an accumulator / degidrator of central air of air
on page forward»
16. System of onboard electric equipment