Removal and installation of tips of steering drafts. BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
11.1. Steering
11.1.1. General information
11.1.2. Removal and installation of tips of steering drafts
11.1.3. Replacement of rubber protective covers of the steering mechanism
11.1.4. Survey, removal and installation of a steering drive
11.1.5. Removal and installation of the steering mechanism
11.1.6. Removal and installation of the pump of the amplifier of a steering
11.1.7. Pumping of hydraulic system of the mechanism of hydrostrengthening of a wheel
11.1.8. Removal and installation of a steering wheel
11.1.9. General information on wheels and tires
11.1.10. General information on installation of corners of wheels and angles of rotation
11.1.11. Diagnostics of malfunctions of a suspension bracket and steering
11.2. Forward suspension bracket
11.3. Suspension bracket of back wheels
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 













11-1-2-snyatie-i-ustanovka-nakonechnikov-rulevykh-tyag.html

11.1.2. Removal and installation of tips of steering drafts

 PERFORMANCE ORDER

  1. Release, but do not remove bolts of fastening of wheels, then поддомкратьте a front of the car and reliably establish it on axial support. Remove a forward wheel.
  1. Measure length of steering draft and write down result of measurement, or put with paint a label on a carving that at assembly to establish a tip in the same situation. Release a collar bolt.
  1. By means of the tool for removal of spherical hinges or a stripper separate a tip of steering draft from the rotary lever.
  1. Unscrew a tip of steering draft.
  2. Installation make upside-down. Make sure that tips of steering drafts are established according to the labels made earlier on a carving. If you measured length of tips, make sure that after installation it corresponds to the earlier measured.
  3. Check corners of convergence of forward wheels, and if necessary adjust them in dealer office of service or in a workshop.


«on page back
11.1.1. General information
on page forward»
11.1.3. Replacement of rubber protective covers of the steering mechanism