Check and adjustment of an air gap (TCI system). BMW the 5th E28/E34 series (from 1981 to 1993 of release)
Repair of BMW E28 and series E34 from 1981 to 1993
1. Cars of the BMW brand of 5-series
2. Engine
3. Cooling system
4. Power supply system
5. Ignition system
5.1. General information
5.2. General information about ignition and precautionary measure system
5.3. Check of functioning of system of ignition
5.4. Check of functioning and moment adjustment ignitions (TCI system)
5.5. Removal and installation of the distributor of ignition
5.6. Check and replacement of the coil of ignition
5.7. Check and replacement of the sensor of impulses and control block ignitions (TCI system)
5.8. Check and adjustment of an air gap (TCI system)
5.9. Check and replacement of sensors ignitions (Motronic system)
6. Control systems of the engine and decrease in toxicity of the fulfilled gases
7. System of production of the fulfilled gases
8. Coupling
9. Manual box of gear shifting (RKPP) and automatic transmission (AT)
10. Transmission line
11. Steering and suspension bracket
12. Brake system
13. Body
14. Control body sizes
15. Heater and air conditioner
16. System of onboard electric equipment
17. Routine maintenance of the car
18. Size table and adjusting data
19. Schematic electric circuits
20. Governing bodies and operation receptions
21. System of onboard diagnostics - a principle of functioning and codes of malfunctions
 






5-8-proverka-i-regulirovka-vozdushnogo-zazora-sistema-tci.html

5.8. Check and adjustment of an air gap (TCI system)

If the radio receiver on your car is equipped with system of protection against abduction, before shutdown of the storage battery be convinced that the correct code of activization is known. Before a detachment of a wire apply for information in the Section System of protection of an audiosystem from theft and language of an instrument guard.


If after battery connection on the display of the dashboard there is a message in other language, for procedure of installation of language address to the Section System of protection of an audiosystem from theft and language of an instrument guard.


 PERFORMANCE ORDER

  1. Disconnect a negative wire of the storage battery.
  1. Insert between a rotor of the sensor and the sensor of impulses bronze щуп. Move shchupy up and down - if a gap correct, at this movement щупа easy resistance will be felt. The gap should correspond the Size table and adjusting data at the end of the Management.
  1. For adjustment of a gap it is necessary the sensor of impulses and the basis to remove with the distributor (look an illustration).
  2. Following item 2-9 of the Section Check and replacement of the sensor of impulses and the control block ignitions (TCI system), weaken screws by which the sensor of impulses is fixed on the basis.
  3. Carefully insert щуп and tighten screws.
  4. Establish in the distributor the removed knot and check adjustment.

«on page back
5.7. Check and replacement of the sensor of impulses and control block ignitions (TCI system)		 on page forward»
5.9. Check and replacement of sensors ignitions (Motronic system)