|
16-11-proverka-i-zamena-shhetok-generatora.html
16.11. Check and replacement of brushes of the generator
Disconnect a negative wire of the storage battery.
Bosch generator
|
|
- Remove from a back part of the generator a tension regulator (look the Section Replacement of a regulator of tension).
|
|
- Measure length of brushes. They should not be shorter than 6 mm. If any of them is worn-out to this limit, replace all set.
|
- Also check on existence of wear of a ring of a collector (look
an illustration).
- Brushes are fixed either screws, or the soldering. If you have not enough experience in the soldering, for installation of brushes, probably, it will be better to address to the electrician.
|
|
Be careful and do not heat up a soldering place more long 5 seconds. If necessary to prevention of an overheat apply a heat-conducting path. It can be executed narrow flat-nose pliers to which should clasp a detail near a soldering place. |
- In case of screw fastening keep knot on a seat and establish screws. Evenly gradually tighten screws that the holder was not bent.
- Establish knot of a regulator of tension on the generator.
- Attach a negative wire of the battery.
|
|
Motorola generator
|
|
- Remove the generator.
- Brushes are established under a regulator tension in a back part of the generator (look
an illustration).
- Remove fixing screws and isolating washers and separate from the case from a collector a regulator of tension and a shchetkoderzhatel.
- Measure length of brushes (look an illustration above). If any of brushes is shorter than 6 mm, replace all set.
- Be convinced that brushes move without jamming in a shchetkoderzhatel.
- Establish щеткодержатель / a tension regulator. Hardly tighten screws. Be convinced that brushes are not short-circuited on the earth.
- Installation is return to removal.
|
|
|
|