16-14-snyatie-i-ustanovka-startera.html
16.14. Removal and starter installation
|
If the starter is faulty, it is necessary to replace or send it for repair to the autoelectrician. Major maintenance of a starter in house conditions is inexpedient, even if there are spare parts. However, the traction relay can be replaced (look the Section Removal and installation of the traction relay). |
Removal
|
- Disconnect a negative wire of the storage battery.
- Lift the car and establish it on props.
- Mark the wires attached to plugs of a starter and the traction relay, then disconnect wires.
|
On some models it is necessary to remove an air purifier (look Head the Power supply system), a broad tank of system of cooling (look Head cooling System) and heater hoses to provide access to the top part of a starter. To avoid mistakes at the subsequent accession carefully mark all hoses and components which act in film in an impellent compartment. |
|
- Working under the car, remove the bottom bolt and a nut of fastening of a starter (are shown by shooters) and remove a starter.
|
|
Removal of a starter from the M40 engine. |
|
|
Installation
Installation is return to removal.
|
|