|
17-8-proverka-urovnya-zhidkosti-sistemy-gidrousileniya-rulya.html
17.8. Check of level of liquid of system of hydrostrengthening of a wheel Two times year or each 10 000 km of run (that will come earlier)
Periodically check liquid level in system of hydrostrengthening of a wheel in order to avoid emergence of problems with management of the car, such, as damage of the steering pump. Act as follows.
|
|
Do not hold a steering wheel turned against the stop in this or that party more than five seconds. It can put out of action the steering pump. |
|
|
On some models the tank of system of hydrostrengthening of a wheel is located in the left part of an impellent compartment and has an unscrewing cover with built in in it measuring the shchupy. On other models the system of hydrostrengthening and the vacuum amplifier, having one general tank located in the right back corner of an impellent compartment is used. |
|
|
- Park the car on an equal platform and cock the parking brake.
|
|
- On models with built in shchupy start the engine and warm up it to normal temperature. With the engine idling turn a steering wheel from an emphasis against the stop several times to remove air from steering system. Switch off the engine, uncover the tank, having turned it counter-clockwise, wipe measuring щуп dry and close a cover. Again open a cover and check liquid level. It should be between two labels.
|
- On models with the vacuum hydraulic booster squeeze out a brake pedal ten times or until it will not start to "resist". Give a nut, uncover and make sure that level of liquid is not lower, than 6.0 mm from tank top.
|
|
- Add liquid small doses while it will not reach the necessary level.
|
|
|
Do not allow a liquid modulation. If it nevertheless happened, remove surpluses with a pure syringe. Close a cover. |
- If it is required frequent having added liquids, check hoses and shtutserny connections of system of hydrostrengthening of a wheel on existence of signs of wear and leaks (see. Section Check of a condition and replacement of hoses of an impellent compartment).
- Check a condition and a tension of a driving belt (see. Section condition Check, adjustment of a tension and replacement of driving belts).
|
|
|
|